virtual audio cable setup two microphones

#Virtual audio cable setup two microphones install

Once there, you’ll want to check the box labeled Listen to this deviceand then select your headset or speakers of choice that you’d like to hear your audio through. Where a Conference Phone 2220 is used, position it in the center of the table so that it is equidistant from all. Right click on this cable, go to Properties, and then visit the Listentab to finish your setup. On a large rectangular table measuring 3.6m x 1.2m (12ft x 4ft), place the microphones 1.2m (4ft) apart, 1.2m (4ft) from the ends of the table. VoiceMeeter Banana audio routing example, splitting audio to headset and stream. For instance, on a circular table place the microphone in the center of the table. Spotify does not have the option to select the output device, but you can force this to an output device, a VAC in this case. This example uses the second virtual input and an additional VAC to split Game/Alert, Discord, and Spotify audio and route them differently Game/Alert audio to both stream and headset, Spotify to the stream only, and Discord to the headset only.įor Discord, you can set the output device in the settings, selecting VoiceMeeter Aux Input (VB-Audio VoiceMeeter AUX VAIO), note the AUX notation. The latter one isn’t free, but it’s the most.

#Virtual audio cable setup two microphones install

In addition, if you have a VAC installed, you can set this as one of the hardware inputs to also use this to receive audio in VoiceMeeter Banana! If you want to play music through your mic in Garry’s Mod (GMod), you’ll need to install two programs: Foobar and Virtual Audio Cable. Make sure that the Enable channel mixing checkbox is cleared and 'Ch mix' is 'off' (channel mixing is disabled). In VAC Control Panel, choose a Virtual Cable and configure its format range to accept a stereo (two-channel) stream. Any input strip with ▶A1 highlighted will go to your headset while any input strip with ▶B1 will go to the stream.Īs you might have noticed, VoiceMeeter Banana has one additional virtual input that you can use. To pack signals from two microphones into left and right channels of a single stream: 1. Now once you have this basic set up, you can control exactly if the audio, from either one of the hardware inputs or the virtual inputs, go to your headset, the stream, or both.